CADMIUM TELLURIDE SINGLE CRYSTAL SUBSTRATES
Twin free single crystal CdTe, lattice matched CdZnTe and CdMnTe epitaxial substrates for MCT infrared detectors.
SPECIFICATIONS:
DOPING: Normally undoped, but may be doped upon request.
SIZES:
Up to
30cm2
area, round, square, or rectangle in shape.
We can meet very tight tolerances on
thickness.
TRANSMISSION:
Guaranteed 50% from 2.5 to 16
microns.
60% available.
PRECIPITATES: 100% I.R. microscopic examination at various magnifications.
ORIENTATION: Normally (111) within 15 minutes. A and B surfaces identified, (100) and (110) within 15 minutes.
EPD: Less than 5x105 (cm2) Nakagawa Etch .
SURFACE FINISH: As sawn, polished on one or both sides per your specifications. Chem Polish on request.
SCREENING: CdTe and CdZnTe substrates are pre-screened to assure no type conversion during L.P.E. and post anneal.
CADMIUM TELLURIDE INFRARED OPTICAL BLANKS AND FINISHED OPTICS
SPECIFICATIONS:
TRANSMISSION: Transmits in the infrared at 67% between 2 and 28 microns with polished uncoated surfaces:
SIZES:
Window blanks of any diameter
between 5mm and 75mm are standard. Thicknesses between 1mm and 1cm
are typical, but are available as long as 6cm. Squares,rectangle and
other configurations are also available on a custom basis.
Dimensional tolerances of plus or minus .002" are typical.
CADMIUM TELLURIDE SINGLE CRYSTAL ELECTRO-OPTICAL MODULATORS
SPECIFICATIONS:
ORIENTATION: Oriented for either AM or PM modulation.
TRANSMISSION: Normally greater than 98% in the center of the beam path.
SIZES: Up to 12 x 12 x 60mm.
ABSORPTION: Less than 0.002/cm at 10.6 micron.
COATINGS: End faces(110) AR coated for 10.6 micron modulation. Coatings for other wavelengths are available.
RESISTIVITY: Greater than 108 ohm/cm when measured in the dark.
ELECTRODES: Chemically etched and Ag-Cu-Au coated.
PARALLELISM: 20 arc seconds or better.
POLISH: End faces polished to Lambda/20 or better.
FINISH:
40/20 or better
BULK MATERIALS
Bulk material and custom
grown boules can be supplied on a toll basis.
