Home

                                                                www.m60joe.com

m60joe@m60joe.com

 

Top Cover Tightening

 

 

Instructions for removing the "slop" between your UZI Top Cover and Receiver.

 Some squeeze the rear of the cover in a vise to make it fit snug but I don't like this method because of the top cover scratching the receiver......

 

One:

Mix JB Weld or equivalent and place a small amount on each side of both ends of the bottom and sides of the top cover.

 

Two:

Cover both ends of your receiver with Saran Wrap. JB Weld doesn't stick to the wrap and the thickness is .0005".  Nice slip fit tolerance as a result.

 

Three:

Place your top cover on the receiver and let sit over night.

 

Four:

Remove the top cover and wrap.